Mercruiser Tilt Trim Gauge Wiring Diagram

Wiring Diagram: Trim Position Sender

What is a Trim Position Sender?

A trim position sender is a device that measures the angle of a boat's trim tabs and sends this information to the boat's control system. This information is used to adjust the trim tabs so that the boat is level in the water.

How to Wire a Trim Position Sender

To wire a trim position sender, you will need the following materials:

• Trim position sender
• Wiring harness
• Electrical tape
• Crimping tool

Once you have gathered your materials, follow these steps:

1. Connect the trim position sender to the wiring harness.
2. Run the wiring harness to the boat's control system.
3. Connect the wiring harness to the boat's control system.
4. Secure all connections with electrical tape.
5. Test the trim position sender to make sure that it is working properly.